PDF Catalogue
toll free: 1.800.676.6123 | HOURS: 6:30AM - 5PM PST

Mounting Bracket for PA-18

Mounting Bracket for PA-18



BRK-19 mounting brackets were designed specifically for track actuators. The brackets consist of 3 parts: 1 T-shape bracket for the motor end mounting hole and 2 L-shape brackets for the sliding block. The T-shape bracket will give the actuator the ability of 180 degree of rotation. Using the mounting brackets will make the installation of the actuator a lot easier. The bracket set includes the previously mentioned T-shaped bracket, 2 L-shape brackets, 1 mounting pin and 1 cotter pin. 


  • Material Type
  • Actuator Model
  • Kit Includes
    2 x L-shape brackets (for sliding block); 1 x T-shape bracket; 1 mounting pin; 1 cotter pin
  • Unit Weight
    0.85 lbs
  • Warranty
    18 Months
3D Models
Dimensional Drawing

Dimensional Drawing

Mounting Bracket for PA-18


We guarantee that all products you receive will be brand new, and have been thoroughly tested for defect and performance before being shipped to you. At Progressive Automations Inc we put our products to the test, stressing their performance in heat, cold, liquid, and under heavy loads and high duty cycles. The specifications listed on our products aren't just approximations, they're backed up by hours and days of testing. We're so confident in our actuators quality, performance, and endurance, that we proudly offer the industry leading 18 month warranty.

All products produced and sold by progressiveautomations.com are covered by our comprehensive 18 month warranty against defect or flaw. If we sell you a product, and it stops working before 18 month pass, we will replace it free of charge. However, the product has to only have been used within its rated parameters and environment conditions.

Please wait...